|
Post by unioncreek on May 21, 2019 8:42:23 GMT -6
I think that my crank sensor has gone bad, car won't start. It's not fuel related. I've seen procedures to test 3 and two pin crnak sensors, but the 01 Aurora has a six pin. Anyone know how to do this?
Bob
|
|
tigger
Administrator
Posts: 2,844
Staff Member
|
Post by tigger on May 21, 2019 9:38:46 GMT -6
On the 3.5, the CKP sensor is actually 2 sensors in 1. So just use your 3 pin procedure for each circuit.
Pin A - 12V Reference B - Low Reference C - CKPS (1) Signal ----- D - 12V Reference E - Low Reference F - CKPS (2) Signal
HTH
|
|