|
Post by antoine9891 on Oct 12, 2014 9:36:42 GMT -6
does anyone know how to replace the drivers side door. My car was hit on the drivers side and i purchased a door from the junk yard. I see that there are bolts on the inside of the door jam but the space is tight. And i do not know how to release the wiring harness to the doors in the door jam. If you know how to do this please post it with pics or a video..
|
|
|
Post by synthesis on Oct 27, 2014 14:55:48 GMT -6
Remove the door panel. The wire harness is a single large connector inside. Unhook it. Disconnect the door "support" in the center of the A-Pillar. Remove the two 10MM bolts holding the door hinge retainers. One on each hinge. Remove the hinge retainer. Disconnect rubber conduit from door, and slide harness through opening in door where conduit was located. Lift door off of hinges, set aside.
Edit: Oops. My instructions are for 2G. Unsure if they are the same on the 1G.
|
|