jettbuell
Aurora Newbie
if it has wheels and a motor, I'll ride it.
|
Post by jettbuell on Dec 9, 2014 7:25:40 GMT -6
I just replaced wheel bearings on car and since then the traction control light comes on after about 20mph. It stays on, can't turn it on or off. I assumed that it has something to do with the connection but I have changed it and checked it out on the wheel end and it seems fine. Is it possible that I need to reset the computer or something of that nature. Any help or suggestions would be great. Thanks.
|
|
|
Post by ohiobuckeye on Dec 9, 2014 10:45:54 GMT -6
All I can tell you is that I changed a front wheel bearing/hub assembly with no problems or need to do any kind of computer reset.
|
|
|
Post by genedjr on Dec 9, 2014 17:58:57 GMT -6
I just replaced wheel bearings on car and since then the traction control light comes on after about 20mph. It stays on, can't turn it on or off. I assumed that it has something to do with the connection but I have changed it and checked it out on the wheel end and it seems fine. Is it possible that I need to reset the computer or something of that nature. Any help or suggestions would be great. Thanks. You do mean hub assembly correct? If you used a really cheap one, you night have issues with the sensor internal to the hub. ...gene
|
|
jettbuell
Aurora Newbie
if it has wheels and a motor, I'll ride it.
|
Post by jettbuell on Dec 11, 2014 10:44:23 GMT -6
I used Moog and yes I meant the hub. I am changing the front rotors in a couple days so I am going to recheck all the connections and wires and clean them real good.
|
|
|
Post by rorafan on Dec 14, 2014 19:45:32 GMT -6
Hopefully you've got this resolved but wanted to throw this out there...I ran into something similar on a GMC Envoy after I replaced the hub/bearing. It ended up being a bad connection. The connector seated properly and all looked fine from from the outside but inside one of the tabs was too thick and got bent downwards when I snapped the connectors together. Bent it back and filed it down and all was well. I did both hubs same day and the other one also gave me problems with seriously messed up threads on the new hub. Sent that one back. As was mentioned earlier, you should not have to reset anything. Good luck!
|
|
|
Post by genedjr on Dec 15, 2014 8:46:46 GMT -6
I used Moog and yes I meant the hub. I am changing the front rotors in a couple days so I am going to recheck all the connections and wires and clean them real good. Any update? As noted you should not have to reset/update anything. Also, schedule the cable clamp, mine had some wear so I added some gorilla tape to protect it. ...gene
|
|