|
Post by sall on Apr 6, 2016 10:42:17 GMT -6
Does anyone know of a good source for factory match leather/vinyl material? Hoping to check out the couple local places this weekend, but thought maybe someone had a source!
|
|
RCA1186
Administrator
Rob
Go Pack Go!
Posts: 4,835
Staff Member
|
Post by RCA1186 on Apr 6, 2016 11:46:30 GMT -6
I researched it a couple years back but it was too hard to tell online (even when the name was right it didn't look right) I think I decided that I was better off just going to an interior place and getting it from them.
|
|
randnon
Aurora Passenger
Posts: 246
|
Post by randnon on Apr 15, 2016 22:13:52 GMT -6
Sal, What are you looking for. I normally strip out the leather seat covers in "Neutral"for spares in-case I rip a panel. They can be sewn in. If it is the 1st gen neutral I may have what you need. Rich in Buffalo
|
|
|
Post by sall on Apr 16, 2016 13:34:14 GMT -6
Sal, What are you looking for. I normally strip out the leather seat covers in "Neutral"for spares in-case I rip a panel. They can be sewn in. If it is the 1st gen neutral I may have what you need. Rich in Buffalo Hey Randnon, I was going to make a shifter boot for a custom shifter surround I have been working on leisurely. As well as recover all the pillars. I am not sure there would be enough usable material from the seat covers.
|
|
randnon
Aurora Passenger
Posts: 246
|
Post by randnon on Apr 17, 2016 6:20:49 GMT -6
Well if it is tan , I would have enough for the shifter cover if needed. You are right that the pillar covers would need bigger pcs. Rich
|
|