dajoe
Aurora Newbie
Posts: 15
|
Post by dajoe on Oct 19, 2016 14:30:08 GMT -6
fixed the corrosion under drivers seat which fixed rear door windows, passenger door window still inop.
Removed panel and did continuity check between lines all ok. You can hear the Door module clicking when switch is pushed.
|
|
dajoe
Aurora Newbie
Posts: 15
|
Post by dajoe on Oct 19, 2016 16:35:08 GMT -6
Also both rear windows will only go half way and the rear drivers side makes a clicking noise when it's full up and when it hits the lowest it will go.
|
|
tigger
Administrator
Posts: 2,844
Staff Member
|
Post by tigger on Oct 19, 2016 19:08:54 GMT -6
Sound like the motor might be toast in front passenger door.
Rear windows only go down about half way. Look at the rear wheel arch, that's as far as they can go, haha! Take the panel off of the 'clicking' door and make sure all the motor and regulator bolts are snug...
|
|
dajoe
Aurora Newbie
Posts: 15
|
Post by dajoe on Oct 20, 2016 15:49:08 GMT -6
Thanks, I'll check that tomorrow
|
|
dajoe
Aurora Newbie
Posts: 15
|
Post by dajoe on Oct 20, 2016 15:54:37 GMT -6
I'll also check for power at the motor. I was thinking maybe the door module was bad the way it was clicking
|
|
dajoe
Aurora Newbie
Posts: 15
|
Post by dajoe on Oct 21, 2016 8:31:01 GMT -6
Had power at the motor so I took the motor off, not much to it. Took it apart to check the bushings. they were good. Put it back together and it works. Maybe it was just on a dead spot
|
|
dajoe
Aurora Newbie
Posts: 15
|
Post by dajoe on Oct 21, 2016 9:46:37 GMT -6
check the motor, all bolts are secure. Is there an electrical/mechanical stop for the motor. It seem like it's just trying to keep going when it reaches the bottom or top
|
|