|
Post by AmunRoo on Oct 22, 2018 14:14:37 GMT -6
First, not sure if this post is in the right place, but I think it is since it may be an electrical issue. So here it is, the passenger rear door works perfectly fine. It opens, closes, locks, unlocks and window rolls up and down. but, i keep getting this stupid error on the DIC and I don't know how to fix it. Anyone familiar with it or would now how to fix this issue. It comes on when I shift out of park, shift out of any drive gear and frankly, it's getting annoying! lol Any help is greatly appreciated. Pic included!
|
|
tigger
Administrator
Posts: 2,844
Staff Member
|
Post by tigger on Oct 22, 2018 17:27:22 GMT -6
My guess would be bad door ajar switch. It's part of the door lock actuator, so you'll have to replace the actuator...
I'll look at the wiring diagram later and see if it can be 'tricked' into thinking it's closed.
|
|
tigger
Administrator
Posts: 2,844
Staff Member
|
Post by tigger on Oct 22, 2018 22:50:42 GMT -6
So here's the wiring for the door ajar switch;
Just use a couple t taps to connect the LT GRN/BLK wire to the BLK/WHT wire (PinB/Connector1 to PinC/Connector1 of the Door module).
As far as the PCM knows, that door is ALWAYS closed, haha!
|
|
|
Post by AmunRoo on Oct 24, 2018 18:05:18 GMT -6
Thank you Tigger, as always... You are the bestest!
|
|
tigger
Administrator
Posts: 2,844
Staff Member
|
Post by tigger on Oct 25, 2018 22:00:56 GMT -6
No problem.
Good luck with the repair (or bypass), haha!
|
|
Paulaurora
Super Moderator
Posts: 3,828
Staff Member
|
Post by Paulaurora on Oct 26, 2018 8:13:38 GMT -6
Make sure there is no broken wires under the carpet or water. One guy from this forum had same thing showing even after her put another door all together . When i put my Tech 2 on his car it was showing that cane even communicate with the module turns out there was water under the carpet and some bad wires
|
|