Paulaurora
Super Moderator
Posts: 3,828
Staff Member
|
Post by Paulaurora on Nov 17, 2015 14:22:47 GMT -6
Hello,
what kind of LED lights i can use inside the speedometer. I have 2 lights that already out and other 3 or 4 is on their way.
is there special sockets i can solder in so i can just buy bulbs in the future .
Thanks for the feed back.
|
|
|
Post by awehlage on Nov 19, 2015 21:39:17 GMT -6
I used 3mm white flat top diffused lens LEDs. You can either solder a resistor in with each LED or put 3 LEDs in a series and solder one resistor. The original halogen bulbs (yellowish emitting color) with a blue silicon boot over to make the cluster look green. If you put a white LED in replacement your cluster will light up blue where you see green and remain red where you see red. No direct PnP replacements like the classic that used t10 based bulbs.
|
|
Paulaurora
Super Moderator
Posts: 3,828
Staff Member
|
Post by Paulaurora on Nov 20, 2015 9:25:44 GMT -6
Thanks awehlage.
|
|
Paulaurora
Super Moderator
Posts: 3,828
Staff Member
|
Post by Paulaurora on Nov 24, 2015 10:05:12 GMT -6
Ok so just used regular bulbs had no time for LEDs. Used tech2 to configure arrow starting points deff was big help with tech 2
|
|
|
Post by awehlage on Nov 24, 2015 18:36:04 GMT -6
wish I had a Tech2 at my disposal!
|
|