Gen 2 Front Seat Cover Fastening

[gui]

My front seat covers are loose at the front. There is a plastic ridge along the frame with corresponding j-channels on the cover that are supposed to snap on the frame piece. The side channels do, but the frame piece doesn't have a "tang" on the inside across the front to hold the cover in place. It's smooth the entire length, so how is this supposed to stay in place?

This is a very rough drawing. I am not very good with a mouse.

Attachments:

[gui]

Disregard, I figured it out. The idiot (I believe the dealership that fixed the leak) that took the seats out when it was soaked from the leaky sunroof didn't put the covers back on right. The front strip on the cover has a reverse tang. I pulled it apart, put it back together correctly (after watching a few videos) and it is back in place. You can tell someone was in there before me, a tool was used to remove the push-in fasteners and they broke some tabs.

[AUROD X]

Thanks for the Drawing, that's good enough. I can see clearly...👍