|
Post by challen66 on Jul 24, 2023 7:04:33 GMT -6
Trying to install a new rear Ignition Control on the Olds 4.0. There is a sensor attached right in the middle of the ICM. I got the front two screws off and the back / top screw but it seems like it's attached to a flex hose in the back. Anyone know how to get this off so I can get to the ICM?
|
|
|
Post by ljhermsen on Jul 24, 2023 9:03:56 GMT -6
|
|
|
Post by AUROD X on Jul 24, 2023 10:17:25 GMT -6
I hated that Job cause it's frustrating. When I was done with job I never installed that Black Bracket again. If I remember there are 2 more Bolts or Nuts (10mm) behind the Head of that bracket and that Valve attached to the Flex Hose there are 2 more 10mm Nuts underneath the Valve. I used a 10mm Rachet close end Wrench. This Job is going to take some time.
|
|
|
Post by challen66 on Jul 24, 2023 10:33:01 GMT -6
Thank you both for your help. I got everything off from the front side but was trying to avoid coming up from the underneath side of the block. At least the bright side is I have practice with the front so it shouldn't take too long.
|
|
Paulaurora
Super Moderator
Posts: 3,829
Staff Member
|
Post by Paulaurora on Jul 24, 2023 21:04:08 GMT -6
I hated that Job cause it's frustrating. When I was done with job I never installed that Black Bracket again. If I remember there are 2 more Bolts or Nuts (10mm) behind the Head of that bracket and that Valve attached to the Flex Hose there are 2 more 10mm Nuts underneath the Valve. I used a 10mm Rachet close end Wrench. This Job is going to take some time. How could you not to put that bracket back The horror lol;)
|
|