|
|
Post by bossdonsin on Jan 19, 2015 19:54:43 GMT -6
doing the driver side muffler as it has holes near the welds...really wanted to do straight pipes but going to go with a walker from the y...apparently there is a clamp pipe that will cover so no welding will be required hopefully? hoping she purrs afterwards...any suggestions or advice would be great...muffler is going on tomorrow.
|
|
|
|
Post by bossdonsin on Jan 21, 2015 23:45:14 GMT -6
was worried about welds ordered two walker quiet fits...nice new shiny tips and all but I think ill take your word...well see next few days what I can figure out...think there may be a decibal law up here...
|
|
|
|
Post by jamezruiz on Mar 2, 2015 20:33:35 GMT -6
was worried about welds ordered two walker quiet fits...nice new shiny tips and all but I think ill take your word...well see next few days what I can figure out...think there may be a decibal law up here... Had walkers ordered myself...was scared that they would be too quiet so right now i have no mufflers or pipes just a lil bit of pipe after the "Y" lol its not too loud at idle and it can run somewhat quiet at certain rpm range 1,300-1,850ish RPM |
|
|
|
Post by bossdonsin on Mar 2, 2015 22:21:33 GMT -6
cant go wrong with walker quiet fits. Similar to original material. They purr.
|
|
