|
|
Post by n3wpv on May 15, 2015 17:34:33 GMT -6
I have an '01 3.5 Aurora. Is it possible to add a Homelink transmitter? I purchased a used overhead console that has the transmitter but it looks like some additional wiring may be needed.
Sent from my GT-N5110 using proboards
|
|
tigger
Administrator 
Posts: 2,844 
Staff Member
|
Post by tigger on May 15, 2015 22:17:32 GMT -6
Just tap power and ground from a map light. It won't be tied to "valet mode" like OEM, but it'll work!
Let me know if you need any wiring info.
|
|
|
|
Post by n3wpv on May 16, 2015 4:55:47 GMT -6
Thanks. Now I just need to find the wiring connector. Any info on that would be appreciated.
Sent from my GT-N5110 using proboards
|
|
tigger
Administrator
Posts: 2,844
Staff Member
|
Post by tigger on May 17, 2015 20:47:51 GMT -6
Can you post a pic of the transmitter (specifically where the connector attaches)? There's tons of Homelink stuff on Ebay, bound to be something that will work, lol!
Might be able to solder in power and ground directly to PCB.
|
|
|
|
Post by n3wpv on May 18, 2015 23:52:06 GMT -6
It's not a good picture of where the harness plugs in.   |
|
|
|
Post by sall on May 19, 2015 7:07:53 GMT -6
Get a connector at the salvage yard or snap the plastic cover piece off and solder wire directly to the PCB traces. Without looking at the manual I don't know which of three pins are power and ground though.
|
|
tigger
Administrator
Posts: 2,844
Staff Member
|
Post by tigger on May 19, 2015 12:04:56 GMT -6
Here ya go,  |
|
