|
|
Post by bossdonsin on Jun 8, 2016 21:08:08 GMT -6
ive had the intake manifold gaskets changed, coil pack, plugs and wires and fuel filter. Have good pressure too...im thinking the cat may be bad? theres been a new gasket put in since ive swapped r subframes...any ideas why its stalling still? It stumbles and dies but starts back up no misses from what I can tell...
|
|
tigger
Administrator 
Posts: 2,844 
Staff Member
|
Post by tigger on Jun 8, 2016 22:58:22 GMT -6
CKP sensor(s)?
|
|
|
|
Post by sall on Jun 9, 2016 7:32:18 GMT -6
Agree with Tigger.
|
|
Paulaurora
Super Moderator 
Posts: 3,825
Staff Member
|
Post by Paulaurora on Jun 9, 2016 8:47:55 GMT -6
TPS sensor
|
|
|
|
Post by Marc on Jun 9, 2016 10:47:58 GMT -6
What Tigger & Sall said.
|
|
skizo
Aurora Passenger
WOT ... is there any other way?
Posts: 278
|
Post by skizo on Jun 10, 2016 14:27:34 GMT -6
Got an error code on the CHECK ENGINE light? I'd been seeing codes for crankshaft position sensor for a long time. Car started stalling at lights when cold, so I decided to finally fix it and see if that helped. Here's the ol' girl on the operating table ...  Real PITA to get done, but no problems since. |
|
tim1993
Aurora Driver
99 Oldsmobile Aurora 4.0L V8
|
Post by tim1993 on Jun 15, 2016 12:53:52 GMT -6
I had issues with mine then come to find out my wire harness for my crank sensor needed to be replaced i had put so much money into tryna figure it out
|
|
|
|
Post by bossdonsin on Oct 25, 2016 20:19:11 GMT -6
when I release my foot off the brake it surges rpm so I'm thinking vacuum leak? what fits?
|
|
