|
Post by scottyaurorav8 on Aug 28, 2022 22:38:26 GMT -6
This is more of a PITA than I expected! I finally got all 6 screws removed from my blower motor. Removing it was tight. I actually broke 2 of the tabs off to pull it loose and out. Is there a trick to this? B.c my concern is the re-install.... All 5 screws up front were easy but that backside screw is so low to the floorboard I can't fit a ratchet in there. The angle is difficult for me even to get a mini wrench on there. Any idea of an easier tool?
Lastly. The resistor next to it (black and silver box with one plug going to it) it's got 2 metal clips on the side of the box and it's popped into the blower motors housing after you remove the blower motor. Is there a trick to remove this box? I managed to remove this black metal bracket covering it (2 screws) to get more room I haven't a clue. I tried pressing it, pulling it. Not sure. Thanks in advance
|
|