removing headlight assembly?

[R4D30N]

does anyone know how?

i did the modded 9005 set yesterday, and i'm not impressed, in fact it upset me a little... my dad did his the proper way, and his 9006 setup is alot brighter..

i read on the site to clean the metal reflctive stuff, and i was curious if anyone knew how to get in there and clean it up?

[onehunglow]

That seems strange - you are saying that a 9006 bulb is BRIGHTER than a 9005? That doesn't make sense since the 9005 consume more wattage and don't have the silver coating on the tip.

When I was modifying my 9005s, I put one in to compare to the opposite 9006 and I do see a difference. You are putting in SILVERSTAR 9005's I assume?

[R4D30N]

yes, i did it exactly according to the site, and it's alot less bright then my dads regular (9006/9005) setup.

[JimW]

i had my driver side assembly removed, the bodyshop was called in, they needed to remove the driver side fender...

I still dont know why. I recommend Ebay replacement, or I have a driver side assembly for $35 USD for sale.

Then I realized it wasnt the headlamp that was faulty it was the seal at the signal...go figure

[R4D30N]

i'm interested in the drivers side assembly, you gotta get me on AIM though, i'll prolly be banned soon

[Zipzag]

to remove the head light you have to remove the splash shield or the fender liner not the fender ,this is so you can rach the the two 10mm nuts holding the light in , the shield is being held in by plastic retainers and they are easy to remove, as far as your not being bright enough , maybe you dont have it properly grounded !

[JimW]

Lets not bring up old threads by a member that has been banned repeatedly and is not welcome on my site

Feel free to start a new thread regarding this topic

Thanx