|
Post by Marc on Mar 1, 2005 15:18:03 GMT -6
I can't find any information in the 2001 factory manual about the rear fog lights. If there's anyone here who has the 2001 manual, do they know where that section is? ________________ GM!!! BRING BACK OLDS!!!
|
|
|
Post by Marc on Mar 1, 2005 21:48:32 GMT -6
To answer my own question, I looked at the rear bumper section of the 2001 factory manual, and it seems that if the rear bumper fascia is removed, the rear fog lights will be accessible. They are attached to the rear fascia. ____________________ GM!!! BRING BACK OLDS!!!
|
|
|
Post by Aurora40 on Mar 2, 2005 11:31:06 GMT -6
Sorry Marc, I meant to reply. I'll check my '02 manual. I'm pretty sure the bulbs are listed along with the other bulb changing stuff. I hope you don't have to remove the bumper to change 'em!!
|
|
|
Post by Custom88 on Mar 2, 2005 11:46:16 GMT -6
you can change them from below the bumper. I changed mine last month. Bulb # 922 will work.
|
|
|
Post by Marc on Mar 2, 2005 14:31:00 GMT -6
Aurora40....From what I was able to see by looking under the rear bumper area, I don't think that the rear bumper would have to be removed to get to the fogs. I was sort of surprised to see that the 2001 shop manual didn't mention the rear fogs at all. ______________ GM!!! BRING BACK OLDS!!!
|
|
|
Post by Silver Surfer on Mar 4, 2005 23:41:02 GMT -6
Fog Lamp Replacement - Rear Removal Procedure
Remove the fog lamp bulb socket from the fog lamp assembly by turning the socket counterclockwise. Remove the nut securing the lamp assembly to the fascia. Push the inboard edge of the lamp rearward to disengage the lamp from the fascia. Remove the lamp assembly from the fascia. Installation Procedure
Position the outboard edge of the fog lamp into the fascia. Push the inboard edge of the fog lamp into the fascia.
Notice Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the nut. Tighten Tighten the nut to 4 N·m (35 lb in).
Install the fog lamp bulb socket to the fog lamp assembly by turning clockwise.
|
|
|
Post by Marc on Mar 5, 2005 11:30:30 GMT -6
Silver Surfer.....Where did you find that info? ____________________ GM!!! BRING BACK OLDS!!!
|
|
|
Post by Silver Surfer on Mar 5, 2005 15:10:05 GMT -6
Just bought the SEi CDs on Ebay. This particular entry came from the 2001 Service Manual section.
|
|